CODELOCKS 5OOO ELECTRONIC Manuel d'utilisateur télécharger pdf (Page 17)

1 Cabinet lock

2 Upper fixing bolt x 2

3 Packer pieces x 2

4 Locking nut

5 Cams x 2

6 Cam fixing bolt

 • Batteries–2x1.5VAAA

 • Templatex1

1

2

3456

Cabinet Lock CL1000

Technical Speciﬁcations

Power 2 x 1.5v AAA cells

Operations 15,000 openings.

Low battery The lock will signal low battery

to the user via the red LED

ﬂashing. The lock will open

100 more times after this signal

is initiated. The non-volatile

memory retains settings when

batteries are changed.

Battery failure override

The Cabinet Locks have been designed so

an external PP3 battery can be placed against

the external contacts and using master code to

gain entry.

External dimensions

Length 136mm (5

3

/8”) x width 32mm (1

1

/4”) x

depth 30mm (1

3

/16”) to top of handle.

Material Zinc Alloy

Buttons Dual epoxy coated buttons

Cam ﬁxing point 8mm (

5

/16”) square

Door thickness CL1004 - 6mm,

1

/4” or less

CL1005 - 12mm,

1

/2” or less

(standard)

CL1006 - 18mm,

3

/4” or less

CL1007 - 24mm, 1” or less

Finish Silver Grey

IP rating IP54 (when ﬁtted with

optional gasket)

For internal use

CODES

Programming information

The Cabinet Lock has three code levels available:

i) Master Code

ii) Sub-Master Code

iii) User Code

The Cabinet Lock is supplied with two factory

set codes:

Master Code: 11 33 55 77

User Code: 22 44

 •WhenttedimmediatelychangetheMaster

Code and User Code.

 •AllMasterCodesandSub-MasterCodes

are 8 digits long – 100,000,000 code

permutations.

 •AllUserCodesare4digitslong–10,000

possible code permutations

 •Thelock‘open’timeissetat4seconds.

FUNCTIONS

Before programming select the most appropriate

function for the application.

A) Repeat code mode

Important Note: This is the default function and

is already pre-programmed in new locks. This is

the most common function and is used where the

same code will be repeatedly used.

B) Single use code mode (locker mode)

The User enters a single use code which will lock

and then open the lock once only and then be

erased. This function is used for short term, multi

occupancy applications e.g. a locker in leisure

centre. The lock will now remain open until the

next single use code is entered into the lock

OPERATING INSTRUCTIONS

Note: The Cabinet Lock has a 10 button

keypad and a #. The # is used when

programming and is found behind the handle

The lock has the following code levels:

Master Code can:

Open the lock

Change the Master Code

Set / Change / Delete the Sub-Master and

User Code, Select between repeated use and

single use codes and Restrict the locked time.

Sub-Master Code can:

Open the lock

Change the Sub-Master

Set / Change / Delete the User Code

User Code can:

Open the lock

Change the User Code

A same code cannot be programmed into

more than one level

CL1000

32

Codelocks2010-A5-Inner.indd 32-33 17/2/10 09:20:13

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 28 29

Commentaires sur ces manuels

Pas de commentaire